2 x 2 twill 3k, fiberglass cloth, wet lay-up, high quality UV protectant clear gel coat, gloss finish
Installation: Double Sided Tape and Self Tap Screws (Hardware provided)
Installation Instructions
Begin the installation process by thoroughly cleaning the designated area with rubbing alcohol. This step ensures the removal of any grease, wax, dust, or other contaminants.
Prior to installation, verify that the product fits perfectly. If there are any uncertainties or fitting issues, please don't hesitate to contact us for assistance.
Crush the 3m primer 94 pen, 1 inch in from the foam applicator to release the primer. Once the primer has saturated the foam tip apply a thin, uniform coating where the carbon part will adhere.
Peel off the high-strength double-sided adhesive from the back of the cover. In cases of relatively low temperatures, enhance the adhesive's effectiveness by warming the installation location with a hair dryer or a heat gun set to a low setting.
Gently position the product in the desired location and firmly press down
